Knowledgebase
Unifore > Help Desk - Pioneer security equipment manufacturer > Knowledgebase

Search help:


Diamond Alarm

Solution

I have a few questions:
The Diamond Alarm is not boosting the signal.
I have 2 Diamonds 1 meter next to each other with a line of side.
1 i have programmed, but the other is not repeating the first one.
Not with the remote or when alarm is triggered.
The distance between the Diamond and a sensor is far less than the wireless range described in the manual (>100 meters)
I have a few sensors witin 8 meters from the Diamond. Only 1 plasterboard is in between and there is no signal between Diamond and sensors!

Hello Marcel,

Thanks for your feedback.

To enable the boosting function, the wireless security sensors into zone 7 of diamond.

Sincerely,

Peter Chen
Unifore Security
http://www.hkvstar.com


Hello Marcel,

To enable the boosting function, the wireless security sensors need to enroll into zone 7 of diamond.

Sincerely,

Peter Chen
Unifore Security
http://www.hkvstar.com


Hi Peter,

I did a test with zone 7.
When alarm is triggered, the light on the diamond is flashing 1 time, but no sound.
It is only flashing on 1 diamond.
The other Diamond is not following.

Hello Marcel,

Thanks for your feedback.

To use the signal booster function, all the wireless security sensors should be enrolled into zone 7.

When sensor is triggered, the diamond will flash one time, but no sound. Because it's forwarding the wireless signal.

Sincerely,

Peter Chen
Unifore Security
http://www.hkvstar.com

 
Was this article helpful? yes / no
Article details
Article ID: 73
Category: Alarm System
Date added: 2017-07-19 09:01:35
Views: 27
Rating (Votes): Article rated 5.0/5.0 (1)

 
« Go back